Scotsman NSE654 Service Manual download pdf (Page 15)

MAINTENANCE AND CLEANING

A Scotsman Ice System represents a sizable investment of time and money in any company’s business. In

order to receive the best return for that investment, it MUST receive periodic maintenance.

It is the USER’S RESPONSIBILITY to see that the unit is properly maintained. It is always preferable, and

less costly in the long run, to avoid possible down time by keeping it clean; adjusting it as needed; and by

replacing worn parts before they can cause failure. The following is a list of recommended maintenance

that will help keep the machine running with a minimum of problems.

Maintenance and Cleaning should be scheduled at a minimum of twice per year.

Electrical power will be ON when doing in place

cleaning.

ICEMAKING SYSTEM: In place cleaning

1. Check and clean any water treatment devices, if

any are installed.

2. Pull out and remove the front panel.

3. Move the ON-OFF switch to OFF.

4. Remove all the ice from the storage bin.

5. Remove the cover to the water reservoir and

block the float up.

6. Drain the water reservoir and freezer assembly

using the drain tube attached to the freezer water

inlet. Return the drain tube to its normal upright

position and replace the end cap.

7. Prepare the cleaning solution: Mix eight ounces

of Scotsman Ice Machine Cleaner with three quarts

of hot water. The water should be between 90-115

degrees F.

8. Slowly pour the cleaning solution into the water

reservoir until it is full. Wait 15 minutes, then

switch the master switch to ON.

9. As the ice maker begins to use water from the

reservoir, continue to add more cleaning solution to

maintain a full reservoir.

10. After all of the cleaning solution has been

added to the reservoir, and the reservoir is nearly

empty, switch the master switch to OFF.

11. After draining the reservoir, as in step 6, wash

and rinse the water reservoir.

To Sanitize:

Mix a solution of approved sanitizer, or use 1

ounce of household bleach and 2 gallons of warm

(95

F. to 115

F.) water. Repeat steps 6-11, except

substitute the sanitizer for the cleaner solution.

12. Remove the block from the float in the water

reservoir.

13. Switch the master switch to ON

14. Continue ice making for at least 15 minutes, to

flush out any cleaning solution.

DO NOT USE any ice produced from the

cleaning solution.

Be sure no ice remains in the bin.

15. Remove all ice from the storage bin.

16. Add warm water to the ice storage bin and

thoroughly wash and rinse all surfaces within the

bin.

17. Sanitize the bin interior with an approved

sanitizer using the directions for that sanitizer.

18. Replace the front panel.

NSE654

January 2000

Page 15

Scotsman Ice Machine

Cleaner contains acids.

These compounds may

cause burns.

If swallowed, DO NOT

induce vomiting. Give

large amounts of water or

milk. Call Physician

immediately. In case of

external contact, flush

with water.

KEEP OUT OF THE

REACH OF CHILDREN.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 28 29

Comments to this Manuals

No comments

Scotsman NSE654 Service Manual Page 15

Comments to this Manuals

Related products and manuals for Ice cube makers Scotsman NSE654