Scotsman MDT6N90 Service Manual download pdf (Page 5)

FOR THE ELECTRICIAN

CONFORM TO ALL APPLICABLE CODES

Connect the electrical power supply for the unit to

the wires in the junction box at the rear of the

machine.

Check the nameplate (located on the back panel)

for the voltage requirements, and for the minimum

circuit ampacity. The machine requires a solid

chassis to earth ground wire.

The ice maker should be connected to its own

electrical circuit so it would be individually fused.

Voltage variation must remain within design

limitations, even under starting conditions.

All external wiring must conform to national,

state, and local electrical codes. The use of a

licensed electrician is required to

perform the electrical installation.

MDT6N90

May 2001

Page 5

POWER SUPPLY

ELECTRICAL

CONNECTION

1 2 3 4 5 6 7 8 9 10 ... 27 28

No comments

Scotsman MDT6N90 Service Manual Page 5