Scotsman CME506 Manual download pdf (Page 33)

Removal and Replacement: Sensors

Electric Eyes (Bin Control / Ice Sensors)

These must be replaced as a set.

1. Remove front panel.

2. Push and release the Off button.

3. Remove top panel.

4. Remove left and right side panels.

5. Unplug both from the System Controller (#3 and

#4).

6. Remove evaporator cover (on models so

equipped).

7. Remove cascading shield (on models so

equipped).

8. Remove cube deflector.

9. Push in at the wire inlets the bin controls.

10. Pull both into the freezing compartment. Pull

wires thru the holes.

11. Remove both bin controls from the freezing

compartment.

12. Reverse to reassemble.

Water Level Sensor

1. Remove front panel.

2. Push and hold the OFF button. Release it when

the machine stops.

3. Trace wire harness from water level sensor to

the Controller (#2). Unplug the harness from the

controller.

4. Lift the pump and mounting plate up enough to

remove the float from the stem.

5. Remove two screws holding the sensor to the

pump bracket and lift the sensor up and out of the

machine.

6. Reverse to reassemble.

Float Stem

1. Remove the front panel.

2. Remove the reservoir cover.

3. Pull up on float stem, reach under pump cover

and pull the float off the stem.

4. Pull stem out and reverse to replace.

Note: Replacement float stems are factory set, but

confirm the settings before installing the new stem:

CME256: Slot size should be between 1

“ and

”.

CME506 or CME656

or CME806: Slot size should

be 2".

Observe machine for proper cube size after

replacement of the float stem.

Water Temperature Sensor

Note: This sensor is replaced as a set with the

Discharge Temperature Sensor.

1. Remove front panel.

2. Push and release Off button.

3. Remove 1 plastic bolt and the reservoir cover.

4. Locate water temperature sensor (inserted into

pump discharge hose).

5. Pull out to remove.

6. Trace back to controller, unplug from #5.

7. Remove the Discharge Line temperature sensor

(see the next page).

8. Reverse to reassemble.

CME256, 506, 656, 806: AutoIQ™ Cubers

January 2002

Page 33

Water Temperature Sensor

1 2 ... 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

Scotsman CME506 Manual Page 33

Comments to this Manuals

Related products and manuals for Ice cube makers Scotsman CME506