Scotsman CME506 Manual download pdf (Page 19)

Additional Maintenance

To drain reservoir completely (if desired):

1. Remove front panel.

2. Push and hold the Off button.

3. Remove screw holding reservoir cover, pull inlet

tube out of reservoir cover, lift cover out of

machine.

4. Unplug water pump connection, remove ground

screw.

5. Remove float from float stem.

6. Unplug water level sensor.

7. Lift pump and sensor out of the machine.

8. Pull up on standpipe to release water.

9. Reverse steps 2-8 to reassemble.

Note: Be certain that the float is fully re-seated on

the stem and the water pump bracket is positioned

properly on the base.

For a proper reservoir rinse, the standpipe must be

vertical and properly seated. There is a key tab

and slot that positions the standpipe in the drain

socket.

10. Push and release Freeze button.

11. Replace front panel.

To Sanitize the Ice Storage Bin

1. Remove all ice.

2. Remove baffle.

3. Switch ice machine OFF or wait for it to be in a

cleaning cycle.

4. Mix a 1 gallon solution of warm (95-115

F.)

water and sanitizer. Follow local codes for

sanitizer.

5. Wash or spray the entire interior of the ice

storage bin with the sanitizer solution. This

includes the bottom of the ice machine and the

inside of the door, the door gaskets (if any) and

door frame.

6. Pour excess sanitizer into the bin to flush the

drain system.

7. If the approved sanitizer requires a rinse, rinse

all interior surfaces with potable water.

CME256, 506, 656, 806: AutoIQ™ Cubers

January 2002

Page 19

Standpipe

Removal of

Reservoir Drain

Standpipe

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Comments to this Manuals

No comments

Scotsman CME506 Manual Page 19

Comments to this Manuals

Related products and manuals for Ice cube makers Scotsman CME506