Scotsman SCN60 User Manual download pdf (Page 9)

Plumbing - Pump Model

Drains

There are two types of ice machine models, one

that drains by gravity and one that has an internal

drain pump.

Drain Pump Model drain installation

1. Locate the coil of 3/8” ID plastic drain tubing

secured to the back of the unit.

2. Route the plastic drain tube from the back of the

unit to the drain connection point.

The drain connection point can be as high as 10

feet above the ice machine. The drain pump

includes a check valve to prevent re-pumping

water in the drain hose.

IMPORTANT NOTE: Often an air gap is required

by local codes between the ice maker drain tube

and the drain receptacle.

Water Supply

The recommended water supply tubing is ¼ inch

OD copper. Stainless steel flex or reinforced PCV

tube may also be used. Install an easily accessible

shut-off valve between the supply and the unit. This

shut-off valve should not be installed behind the

unit.

The water connection is at the back of the cabinet.

Connect using a compression fitting, one is

supplied tied to the water inlet tube at the back of

the cabinet. When built in: Coil enough tubing

behind the machine so it can be pushed into the

cavity without kinking the tubing.

May 2011

Page 8

SCN60

User's Manual

Pump Drain

Discharge

Tubing

Connect Water Supply

Here, fitting is supplied in

bag tied to tube

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

No comments

Scotsman SCN60 User Manual Page 9