IntroductionThis product manual is intended for users andservicers of the CSWE1 Automatic Ice Machine.Table of ContentsSpecifications: . . . .
CondenserThe air cooled condenser will also need to becleaned periodically.1. Turn the control knob to OFF.2. Remove the two screws in the lower grill
Service DiagnosisProblem Probable Cause Possible SolutionCompressor will not run, no ice inbinLocated in cold area Move to warmer area (above55oF.)Pow
Service DiagnosisProblem Probable Cause Possible SolutionExcessive water dripping on ice Water pan overflowing Check overflow tube forrestrictions. Ov
Service DiagnosisProblem Probable Cause Possible SolutionWater pump will not run Pump binding in housing Locate and remove cause ofbindingOpen circuit
Operational CharacteristicsWater Solenoid Valve.25 GPM flow rateEvaporatorStainless steelRefrigerant Charge6.75 oz. of R-134aRunning amps3.5Cutter gri
IndexAAdjustment . . . . . . . . . . . . . . . Page 5, Page 11, Page12CCleaning . . . . . . . . . .
Specifications:This ice machine requires 115 volts AC. It isdesigned only for indoor installations, in acontrolled environment.Limitations: Minimum Ma
Installation:Proper installation is a necessity, because animproper installation will cause operationalproblems that are NOT covered by any warranty.
Plumbing:Connect a 1⁄4" OD copper tube to a threadedcompression fitting on the inlet water valve. Thereis an access hole in the back of the cabin
Initial Start UpNote: If the ice machine is installed above 2,000 ft.the bin and evaporator thermostats well need to beadjusted. Remove the thermostat
Changing the bin door and lower panels.The bin door and lower panels can be customizedto match wood cabinets. The size of the door panelis: 11 1⁄4&quo
What to expect:When the machine is on, and making ice thecompressor, fan motor and water pump will be on.Periodically, the water pump and fan will sto
Maintenance:The water system, including the filter screen in theinlet water valve, needs to be cleaned periodically.Instructions are located on the in
Cleaning the interior components.1. Turn the cycle control knob to "Off" anddisconnect the electrical power supply to the icemachine. Open t
Comments to this Manuals